Proper lubrication reduces friction, prevents corrosion, and extends bearing life. Methods include:
1. Drip Lubrication: For low/mid-speed bearings (<5 m/s). Adjust drip rate (3–8 sec/drop). Over-lubrication causes overheating.
2. Manual Lubrication: For light loads or intermittent use. Use filtered covers to prevent contamination.
3. Oil Ring Lubrication: For horizontal shafts (>50 mm diameter). Use one ring for width/diameter ratio <2.
4. Oil Bath Lubrication: Immerse bearings partially; oil level below the lowest roller center.
5. Circulating Oil: For high-speed bearings. Filtered oil cools and lubricates via a pump system.
6. Spray Lubrication: For high-speed/high-temperature bearings. Compressed air delivers oil mist while cooling.
Key Notes:
Maintain seal water pressure and adjust packing to prevent leaks.
Keep bearings clean; operating temp ≤ 65°C (max 75°C).
Ensure motor-pump alignment and inspect coupling elastomers regularly.
Monitor wear-prone parts and replace them promptly.
Choose lubrication methods based on speed, load, and environment to optimize pump performance and longevity.
Our professional slurry pump team is always At your services.
Contact: Ms.Serena Zhang
Tel: +86 13333119820
Email: sales@cnsmepump.com
WhatsApp: +86 13333119820
Add: 260# West Huaian Road, Shijiazhuang, Hebei, China. 050051.