The basic part number for the slurry pump adjusting screw is 001, and its function is to adjust the impeller clearance

Slurry pump grease retainer basic part number is 046, its function is to keep grease in bearings area.Slurry pump grease retainer are normally made in grey iron material, ductile iron and steel are also available

Slurry pump labyrinth locknut basic part number is 061, its function is to fasten the labyrinth of drive end

B15110A05 volute liner is an important high chrome wet-end parts for 2/1.5B-AH slurry pump important high chrome wetted parts of 2/1.5B-AH slurry pumps

Il rivestimento della piastra di copertura in gomma della pompa per fanghi è la principale parte soggetta ad usura per la pompa per fanghi rivestita in gomma

Il rivestimento della piastra di copertura in gomma protegge l&39;alloggiamento della pompa e i componenti chiave dall&39;impatto e dall&39;usura dei fanghi, garantendo un funzionamento stabile e a lungo termine

gravel pump door FG108013A05 is used for 10/8F-G sand gravel pump, and one of important gravel pump parts, the gravel sand pump spares mainly included impeller, frame plate,bowel, back liner , door and frame plate liner insert etc

L&39;anello lanterna della pompa per fanghi è solitamente installato nella sezione cuscinetto della pompa per fanghi, situato nel collegamento tra l&39;albero della pompa e il corpo della pompa. L&39;anello della lanterna svolge un ruolo cruciale nel migliorare le prestazioni della pompa per fanghi, riducendo i guasti e prolungando la durata utile dell&39;attrezzatura

The gland assembly is located at the pump shaft sealing area. It works with the stuffing box to prevent slurry leakage from the pump shaft, providing a sealing effect. By adjusting the pressure, it helps extend the equipment’s lifespan and reduce slurry leakage

The seal of the Expeller of the slurry pump is sealed by the hydrodynamic action, which belongs to the non-contact seal. The air or clean water generates pressure under the rotating action of the Expeller, and forms an air slurry or water slurry balance with the slurry at the outer edge of the Expeller, thus resisting the leakage of the liquid at the outlet of the main impeller

Slurry Pump Frame Plate Liner Insert is a wear part of slurry pumps, It is also called for the slurry pump back liner based on locating position in the slurry pump structure, Frame plate liner insert forms a pump chamber with throat bush and volute liner where the slurry would flow through them, CNSME offers frame plate liner inserts are interchangeable with warman pump frame plate liner inserts with high chrome, natural rubber, polyurethane for different working condition

Throatbush is one of the wet (end) parts of slurry pumps. It links cover plate /front casing of the pump outer casings and forms a pump chamber to work with impeller